CCNA 640-802: NAT SIM

Question:
A network associate is configuring a router for the weaver company to provide internet access. The ISP has provided the company six public IP addresses of 198.18.184.105 198.18.184.110. The company has 14 hosts that need to access the internet simultaneously. The hosts in the company LAN have been assigned private space addresses in the range of 192.168.100.17 – 192.168.100.30 .

CLICK ON IMAGE TO VIEW

Click Knowledge Base for NAT SIM to learn the concepts before attempting or learning this SIM Question

NAT SIM Configuration:

The following configuration translates between inside hosts (Weaver LAN) addressed from 192.168.100.16 /28 network (192.168.100.17 – 192.168.100.30) to the globally unique pool of address provided by ISP 198.18.184.105 – 198.18.184.110 /29.

Weaver>enable
Weaver#configure terminal

Before starting the NAT configuration verify that router hostname currently configured is weaver. If not change hostname to Weaver using the command

Router(config)#hostname weaver

Step1: Create an access-list to match all the Weaver LAN address that need to be the candidates for NAT translations

Weaver(config)#access-list 10 permit 192.168.100.16 0.0.0.15

Step2: Create a NAT Pool with pool name isp_adr and specify the pool address range provided by ISP with their netmask.

Weaver(config)#ip nat pool isp_adr 198.18.184.105 198.18.184.110 netmask 255.255.255.248

Step3: Packets that match access-list 10 will be translated to an address from the pool called "isp_adr".

Overload keyword specify to use Port based NATing to support all the Weaver LAN address range.

Weaver(config)#ip nat inside source list 10 pool isp_adr overload


SIM Question already provides that appropriate interfaces have been configured for NAT Inside and NAT Outside statements.

For your information configuration would have been like this

Weaver(config)#interface fastethernet 0/0
Weaver(config-if)#ip nat inside

Weaver(config)#interface serial 0/0
Weaver(config-if)#ip nat outside


Functionality Test:
Our requirements are to allow the hosts (Weaver LAN) the ability to communicate with the Internet. For this test, we ping the Internet device (ISP router S0/1) from Host for testing.

Step1:
Go to host for testing:
C:\>ping 192.0.2.114

PING should be success to 192.0.2.114 since SIM question provides that static route is already configured on router.


Step2:
On console of router (Weaver) :
Issue show ip nat translation command to verify the NAT translations.

Sample output:
Considering host for testing IP address is 192.168.100.17

weaver# show ip nat translation

Pro Inside global Inside local Outside local Outside global
icmp 198.18.184.105:434 192.168.100.17:434 192.0.2.113:434 192.0.2.114:434
icmp 198.18.184.105:435 192.168.100.17:435 192.0.2.113:435 192.0.2.114:435
icmp 198.18.184.105:436 192.168.100.17:436 192.0.2.113:436 192.0.2.114:436
icmp 198.18.184.105:437 192.168.100.17:437 192.0.2.113:437 192.0.2.114:437
icmp 198.18.184.105:438 192.168.100.17:438 192.0.2.113:438 192.0.2.114:438

Any Questions on SIMULATOR welcomed.
Best of LUCK to your CCNA EXAM